|
Hum and Noise: (20Hz-20kHz).
Below full power typically: -115 dB
Min. unweighted: better than -100dB
Input Sensitivity:
1,2 V RMS for full output
Input Impedance:
At all level settings from balanced and unbalanced sources: 40 kOhms
Input Stage Common Mode Rejection:
100 dB typically, better than 90 dB at 50 Hz, even better at other frequencies.
Load Impedance:
No minimum impedance. Designed for 1 Ohm to 10'000 Ohm systems. Can drive any speaker impedance (even below 1 Ohm) with dynamic (music) signals without any limiting, compression or other negative effects on the audio signal. Despite this, the amplifier is fully protected against short circuits, open circuits and all other adverse conditions via a unique onboard computer that continuously surveys all important parameters.
|
